Microsoft Exam Dumps

QUESTION 41
Which two are functional layers of a collapsed-core LAN design? (Choose two.)

A.    core
B.    aggregation
C.    access
D.    distribution
E.    services
F.    Company 1

Answer: AC

QUESTION 42
Which two Cisco data center devices can participate in FabricPath? (Choose two.)

A.    Cisco Nexus 5500 Series Switches
B.    Cisco Nexus 1000V
C.    Cisco Nexus 7000 Series Switches
D.    Cisco Nexus 4900 Series Switches
E.    Cisco MDS 9500 Series directors

Answer: AC

QUESTION 43
Which item best describes the STP requirements for Cisco FabricPath?

A.    RPVST must be configured on every Cisco FabricPath VLAN.
B.    RPVST must be configured on every Cisco FabricPath Border interface.
C.    MST must be configured on every Cisco FabricPath VLAN.
D.    MST must be configured on every Cisco FPBI.
E.    STP is required only to resolve border link failures.
F.    STP is not required on Cisco FabricPath interfaces.

Answer: F

QUESTION 44
Which three are features of Cisco OTV? (Choose three.)

A.    control plane-based MAC learning
B.    dynamic encapsulation
C.    MAC address learning based on flooding
D.    pseudo wires and tunnels
E.    complex dual-homing
F.    native automated multihoming

Answer: ABF

QUESTION 45
Which is a key characteristic of virtual device contexts?

A.    allowing logical switches to be aggregated into a single physical switch
B.    allowing logical switches to be aggregated into multiple physical switches
C.    allowing physical switches to be partitioned to a single virtual switch
D.    allowing physical switches to be partitioned to multiple virtual switches

Answer: D

QUESTION 46
Which three are characteristics of the SAN core-edge design? (Choose three.)

A.    few devices to manage
B.    deterministic latency
C.    lower oversubscription
D.    fewer ISLs
E.    easy to analyze and tune performance
F.    cost-effective for large SANs

Answer: BEF

QUESTION 47
Which two Cisco Nexus switches are capable of Layer 3 switching? (Choose two.)

A.    Cisco Nexus 7010
B.    Cisco Nexus 5020
C.    Cisco Nexus 5548
D.    Cisco Nexus 2248
E.    Cisco Nexus 2232

Answer: AC

QUESTION 48
Which command pings from the Cisco Nexus 5548 interface mgmt 0 to host 10.10.1.1?

A.    ping -m 10.10.1.1
B.    ping 10.10.1.1 -m
C.    ping 10.10.1.1 vrf management
D.    ping 10.10.1.1 vrf default

Answer: C

QUESTION 49
Which two are configuration elements selected during initial setup of the Cisco MDS 9100 Series Fibre Channel Switches? (Choose two.)

A.    Telnet bits
B.    SNMPv3 community strings
C.    Zone port distribution
D.    Enforce password complexity
E.    Default switchport mode F

Answer: DE

QUESTION 50
Which two are configuration elements selected during initial setup of the Cisco Nexus 7000 Series Switches? (Choose two.)

A.    Telnet bits
B.    SNMPv3 community strings
C.    VDC mode
D.    Default interface layer
E.    Default interface state
F.    CoPP

Answer: DE